Viper 2 Step 2 Exam Your email address: Your name: Company name: Start Quiz! 1. Which of the following best describes the condition that you should expect the crate to arrive in? Holes in it The TiltWatch indicator has been tripped Overall good condition The top is missing Question 1 of 20 2. Which of the following is NOT true about removing your Viper from the crate? Use two people to lift the machine What is shipped with the machine may vary, based on how you ordered your machine Do not lift from underneath the bed, always use the sides of the machine Place the machine on an ordinary folding table Question 2 of 20 3. The machine is heavy, but it is lighter than the crated weight? True FalseQuestion 3 of 20 4. We highly suggest using a UPS power supply, to help protect your equipment? True FalseQuestion 4 of 20 5. Why is there a support bracket on the back of the machine? It is left over from a previous application of the cabinet To keep the USB cable away from the platen, as it is printing To keep the power cord away from the platen, as it is printing It is used as a handle, when taking the cover off of the machine Question 5 of 20 6. Which part, is not a real part, in the Viper 2? Layer button A carriage A pressure pump Bulk ink bottles Question 6 of 20 7. We want to make sure the ink is fully loaded in the machine, before we align the platens? True FalseQuestion 7 of 20 8. What item(s) do we prefer to use as a height gauge? Quarters Your cell phone A piece of wood One of your fingers, but you must make sure you use the same one throughout the process Question 8 of 20 9. We use a 10mm box wrench, or an adjustable wrench, to adjust the height of the platen? True FalseQuestion 9 of 20 10. When aligning the platen, we measure the distance from the top surface, down to the base of the platen, in each corner? True FalseQuestion 10 of 20 11. How do we turn off the gap sensors, so the bed will not try to adjust the bed height, if we interrupt (break) the sensor beam? We turn off the power at the control panel We press the emergency stop button We press the layer button and the power button (on the control panel), at the same time We press the bed up and bed down buttons at the same time Question 11 of 20 12. Every corner of the platen must be the same distance away from the print head, when the platen is aligned properly? True FalseQuestion 12 of 20 13. The Viper 2 standard platen, comes with 3 different size plastic adaptors? True FalseQuestion 13 of 20 14. Your largest print area is about 11in by 16in? True FalseQuestion 14 of 20 15. Which of the following, best describes, what should be on the bottom of your standard platen A cork strip Two cork strips Teflon tape Two cork strips and Teflon tape Question 15 of 20 16. When running major production, it is best to have multiple platens, to keep the machine printing? True FalseQuestion 16 of 20 17. When operating in a standard 2 up platen configuration, where do we usually want the collar positioned? Toward the control panel Toward the front of the machine Toward the ink cartridges Toward the back of the machine Question 17 of 20 18. The gap sensor is what determines how far from the print head the garment will be, during the printing process? True FalseQuestion 18 of 20 19. When you set the gap height, and you release the bed up button, what should the bed do? Nothing Raise slightly Load into the machine Lower slightly Question 19 of 20 20. The machine will always, automatically set the gap height, by just loading the platen into the machine? True FalseQuestion 20 of 20 Loading…